1、Plating into a transition will create a stress concentration that can cause crack initiation.
如果過渡段被電鍍(倒角和內切槽)將會產生應力集中，造成裂紋。

2、And the paper shows a reasonable connecting form by comparing stress concentration coefficients.
通過對應力集中系數的比較，提出了較為合理的連接形式。

3、The Phenomena of stress concentration of tubular T joints are investigated widely in this paper.
本文對T型管狀接頭的應力集中現象進行了廣泛的研究。

4、The stress concentration factor of cylinder is much larger than that of other three kinds.
圓柱形顆粒的應力集中在基體達到屈服后要遠遠高于其他三種顆粒。

5、Stress Concentration Effects on Life of Riveted Railway Bridges
鉚釘孔應力集中對“老年”鉚接鋼橋壽命的影響

6、Finite element analysis shows that there are three stress concentration areas inside the bearing.
有限元分析表明，軸承內部存在三個應力集中區域。

7、Tectonic Stress Concentration of Outburst Da,ngerous Area
突出危險區域的構造應力集中

8、A Solution for Stress Concentration in Orthotropic Plate with Hole by BEM
用邊界元法求解帶孔的正交各向異性板問題

9、The expression for calculating dynamic stress concentration factor is presented.
給出了動應力集中系數的計算表達式。

stress concentration翻譯