1、Here we can see a typical thermogravimetric analysis.
現在我們可看到典型的熱解重量分析法。

2、And the thermal stability was taken by thermogravimetric measurements.
通過熱失重實驗，對其熱穩定性進行了測試。

3、Thermogravimetric Kinetic Analysis of PC/ABS/montmorillonite Nanocomposites
聚碳酸酯/ABS/蒙脫土納米復合材料的熱重動力學分析(英文)

4、The existence of MPS is examined by thermogravimetric analysis and contact angle testing.
熱重分析和接觸角測試驗證了粒子表面MPS的存在。

5、Thermal oxidation of carbon nanotubes in air was performed by thermogravimetric experiment.
碳納米管在空氣在的熱氧化性由熱重實驗測定。

6、Dynamic thermogravimetric analysis of PP and the nanocomposites was performed.
利用動態tga方法研究了聚丙烯和納米復合材料的熱穩定性。

7、The thermogravimetric analysis shows that it possesses good thermal stability.
熱重分析表明該化合物熱穩定性較好。

8、The grafted products were characterized by thermogravimetric analysis and FTIR.
結果：對納米粒進行了熱重分析和紅外表征。

9、The thermal stability of the nanocomposites was investigated using thermogravimetric analysis.
通過熱重分析考察了復合材料的熱性能。

10、Thermogravimetric analysis demonstrated that the graft ratio was 2.69%.
熱失重分析結果表明：碳纖維表面的接枝率為2.69%。